BIXOLON SPP-R300 Especificações descarregar pdf (Página 87)

SPP-R300 Command Manual

Rev. 1.00 BIXOLON

- 87 -

GS ( E

Function: Set NV user memory area

Code:

None

Range:

None

Default:

None

Description:

This command stores the customized values to the NV user memory area and uses them for the printer operation. The

table below explains the functions available in this command. Executes commands related to the user setting mode by

specifying the function code fn.

fn Format No. Function

1 GS ( E pL pH fn d1 d2 1 Start the user setting mode

2 GS ( E pL pH fn d1 d2 d3 2 End the user setting mode (Performs a soft reset)

GS ( E pL pH fn [a1 b18...b11]...

[ak bk8...bk1]

3 Set value(s) for the memory switch

4 GS ( E pL pH fn a 4 Transmit the settings of the memory switch to the host

5 GS ( E pL pH fn a 5 Specify the paper width

6 GS ( E pL pH fn a 6 Transmit the paper width

11 GS ( E pL pH fn a d1...dk 11 Set the communication conditions for the serial interface

12 GS ( E pL pH fn a 12 Transmit the communication conditions for the serial interface

Remarks:

■ pL, pH is used to set the number of bytes following pH to (pL + pH x 256).

■ The change in the items of the NV user memory is available only after entering the user setting mode.

■ After completing the user setting mode (Function 2), the printer performs software reset to restore the initial settings

in effect at power on. Receive and print buffers are cleared as well.

■ Since frequent write operation by this command may deteriorate the performance of the NV memory, it is

recommended to write to NV memory when the significant change in the setting is required.

■ While processing this command, the printer remains busy. Therefore the data transmission by the host is not

available. The real time commands and ASB operations are not processed.

Differences:

■ Function (1,2,3,4,11, 12) are supported

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 148 149

Sem comentários

BIXOLON SPP-R300 Especificações Página 87